Meridian America Link/Customer Controlled Routing - Manual (Page 510)

492 Chapter 15: Link configuration
553-3202-210 Standard October 1998
Procedure 14: Changing Meridian Link (link 1) parameters (continued)
Table 142
X.25 and LAPB parametersÑLink 1 (continued)
Link parameter Allowed values
(defaults in parentheses)
Description
Maximum trans attempts
(N2) 1Р(8)Р9999 Maximum number of retries to
complete a transmission; must
be identical to the number
specified on the host computer
configuration
Local DTE address 000000990100 X.25 Òcall requestÓ address that
identifies the AM. When the host
sends the X.25 call request
packet to set up the SVC, it must
specify the AMÕs local DTE
address. The default value is
000000990100.
X.25-only parameters:
Flow control negotiation (0)Ð1 An X.25 service that allows flow
control parameters (packet size
and window size) to be
negotiated between the host and
the AM. Not supported by the
AM. Default value is 0 (no flow
control negotiation). Use flow
control negotiation (packet size
and window size) 0 = no;
1 = yes.
Incoming packet size 16 32 64 (128) 256 512
1024 2048 4096 Maximum X.25 packet size; must
be identical to the size specified
on the host computer
configuration
Outgoing packet size 16 32 64 (128) 256 512
1024 2048 4096 Maximum X.25 packet size; must
be identical to the size specified
on the host computer
configuration
Ñ continued С