Meridian America Link/Customer Controlled Routing - Manual (Page 149)

Chapter 8: Hardware installation procedures 131
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Table 31
MVME333-2 XCC card jumper settings
Block Jumper setting
K1
K2
K3
K4
K5
K6
K7
K8
K9
2 and 4, 6 and 8, 10 and 12, 13Р14, 15Р16, 23Р24
none
1Р2, 5Р6, 7Р8, 9Р10
none
1Р2, 3Р4
5Р6
5Р6
none
1Ð2
6 Replace the MVME333-2 XCC card and replace the screws at the
top and bottom of the faceplate.
7 If you are checking the option settings for an Application Module
installed on the left side of the AEM, go to step 5. If the Application
Module is preinstalled on the right side of the AEM, remove it as
follows:
¥ If you have an I/O subpanel, loosen the five spring-loaded
screws that hold the I/O subpanel to the I/O assembly of the
AEM. Gently set the panel in the back of the Application Module
so the cables do not come in contact with the edges of the AEM.
¥ If you have a universal I/O panel or a generic I/O panel, remove
the screws at the edges of the I/O panel. Gently set the panel in
the back of the Application Module.
¥ Detach the orange logic-return ground wire that is screwed to
the terminal block at the bottom of the AEM.
¥ Unplug the yellow and gray cable (NT7D52AA) that connects the
power sense card to the power monitor.