Meridian America Link/Customer Controlled Routing - Manual (Page 484)

466 Chapter 14: Software installation, upgrade, and update procedures
553-3202-210 Standard October 1998
Procedure 8: Load the application software from tape (continued)
If you have purchased CCR, go to step 20.
Figure 241
CCR customer number prompt
Please enter the CCR customer number (0-99):
20 You are prompted to enter your CCR customer number (Figure 241).
Type the number and press [Return].
Figure 242
Ethernet connection prompt
Installing NSE R3V7.1. Please wait.
Is your module connected to the Ethernet (y/n) ?
21 You are asked whether your IPE Module or Application Module is
connected to Ethernet (Figure 242).
Note: Your module must be connected to Ethernet before you type y.
For more information about Ethernet connections, refer to ÒInstalling
Ethernet LAN supportÓ in Chapter 9, ÒMeridian Link/CCR interface
cabling.Ó
If your module is not connected to Ethernet, type n and press
[Return]. Go to step 25.
If you are connected to Ethernet and you plan to use it in the near
future, type y and press [Return]. You see a message asking you to
wait. Then you see more installation messages (Figure 243). Go to
step 22.
If you are connected to Ethernet but do not plan to use it in the near
future, you may choose to type n and press [Return]. Disabling
Ethernet support increases the processing power available to your
application(s). Go to step 25.