Meridian America Link/Customer Controlled Routing - Manual (Page 147)

Chapter 8: Hardware installation procedures 129
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Checking the card option settings (Application Module)
The cards are shipped with the settings preset at the factory, and they need
to be checked only if you suspect a problem, or if you need to configure the
host computer port (on the MVME705B card) for DTE operation. If you
want to check the settings during installation, do so before installing the
Application Module.
The following procedure for checking the transition card option settings is
one of a series of procedures you perform to install an Application Module.
The series is shown in Table 12 in Chapter 5, ÒHardware installation
overview.Ó
To check the option settings on the MVME712A, MVME712AM,
MVME712M, and MVME705B transition cards, you must remove the cards
from the rear of the Application Module. If the Application Module is
installed on the right side of the AEM (when viewed from the front of the
AEM), it must temporarily be removed to access the transition cards. You
do not need to remove the cards in the front of the Application Module to
remove the module.
Note: If the Application Module is installed on the left side of the
AEM (facing the AEM), you can check the transition cards without
removing the Application Module.
!
CAUTION
Risk of personal injury
Be careful when installing an Application Module
because it is heavy. This is usually a two-person job.