Lenze 8400 BaseLine D - Manual (Page 109)

Lenze · 8400 BaseLine D · Reference manual · DMS 5.5 EN · 01/2014 · TD05
109
6 I/O terminals
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6 I/O terminals
This chapter provides information on the function, possible parameter settings, and technical data
of the input/output terminals of the controller.
In the »Engineer«, the digital and analog input and output terminals are parameterised on the
Terminal assignment tab. To do this, go to the Control terminals list field and select the terminals
that you wish to parameterise:
You can find further information in the respective subchapter:
 Digital terminals ( 110)
 Analog terminals ( 112)

Tip!
How you can alter the preconfigured assignment of the input and output terminals is de-
scribed in the chapter entitled " User-defined terminal assignment ". ( 115)

Note!
The input and output terminals of the controlelr are already functionally assigned in the
default setting ("Lenze setting"). The preconfigured assignment depends on the control
mode selected in C007 .
 Terminal assignment of the control modes ( 137)