9 identify motor parameters, Identify motor parameters, 4device control (dctrl) – Lenze 8400 BaseLine D User Manual
Page 53
Lenze · 8400 BaseLine D · Reference manual · DMS 5.5 EN · 01/2014 · TD05
53
4
Device control (DCTRL)
4.1
Device commands
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.1.9
Identify motor parameters
The
= "1: On / start" device command performs automatic identification of the motor pa-
rameters.
• The device command is only executed when the drive controller is in the "
" state.
• In order to identify the motor parameters, the controller must be enabled after this device com-
mand.
• After that it changes to the "
• After the execution of the identification, it changes back to the "
" device state.
Tip!
Detailed information on automatic identification of motor parameters can be found in the
"
Automatic motor data identification
" subchapter on motor control (MCTRL).