Lenze 8400 BaseLine D - Manual (Page 66)

5 Motor control (MCTRL)
5.1 Motor selection/Motor data
66
Lenze · 8400 BaseLine D · Reference manual · DMS 5.5 EN · 01/2014 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.1 Motor selection/Motor data
The motor data term comprises all parameters that only depend on the motor and that only charac-
terise the electrical behaviour of the machine. The motor data are independent of the application in
which the controller and the motor are used.

Proceed as follows to open the dialog for parameterising the motor data:
1. »Engineer« Go to the Project view and select the 8400 BaseLine D controller.
2. Go to Workspace and change to the Application parameters tab.
3. Go to the Overview dialog level and click the following button:
Parameterisation dialog in the »Engineer«
• Via the from Motor Catalogue button, the motor catalogue can be opened to select another mo-
tor.

Selecting a motor from the motor catalogue in the »Engineer« ( 69)
• Via the From drive... button, the motor data set in the controller can be copied to the »Engineer«
when an online connection has been established.