Lenze 8400 BaseLine D - Manual (Page 143)

Lenze · 8400 BaseLine D · Reference manual · DMS 5.5 EN · 01/2014 · TD05
143
8 Diagnostics & error management
8.2 Drive diagnostics with the »Engineer«
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8.2 Drive diagnostics with the »Engineer«
When an online connection to the controller has been established, the connected controller can be
diagnosed and relevant actual controller states can be displayed in a clearly arranged visualisation
using the »Engineer« :

Information on the drive diagnostics with the integrated keypad can be found in the
chapter "Introduction" in the subchapter " Internal Keypad ":
 LED status display ( 19)
 Display messages ( 20)
Button Function
 Display all active sources of a controller inhibit.
 Display all active sources of a quick stop.
Resetting an error Acknowledge fault message (if the error cause has been eliminated).
Logbook... Display the Logbook of the controller. ( 146)
Monitoring... Configure the Monitoring . ( 148)
Device state... Display the internal state machine including the current device state.
Drive control... Display the bit assignment of the following control-related words:
• Cause of controller inhibit ( C158 )
• Cause of quick stop QSP ( C159 )
• Status word ( C150 )
• Extended status word ( C155 )
Device information... Display identification data, e.g. information on firmware version.