Displaying and maintaining wlan roaming – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 102
90
Step Command
Remarks
5.
Add a member.
member { ip ipv4-address | ipv6
ipv6-address } [ vlan vlan-id-list ]
By default, no member exists in a
mobility group.
Members can be added
dynamically irrespective of
whether IACTP service is enabled
or not.
6.
Specify an IACTP control
message integrity
authentication mode.
authentication-mode
authentication-method [ cipher |
simple ] authentication-key
Optional.
By default, IACTP control message
integrity authentication is
disabled.
7.
Enable the IACTP service for
the group.
mobility-group enable
By default, IACTP service is
disabled.
NOTE:
•
Do not configure ACs in a mobility group to back up each other.
•
ACs in a mobility group must have the same user profile configurations.
Displaying and maintaining WLAN roaming
Task Command
Remarks
Display mobility group
information.
display wlan mobility-group
[ member { ip IPv4-address | ipv6
IPv6-address } ] [ | { begin |
exclude | include }
regular-expression ]
Available in any view
Display the roam-track information
of a client on the HA.
display wlan client roam-track
mac-address mac-address [ |
{ begin | exclude | include }
regular-expression ]
Available in any view
Display the WLAN client roaming
information.
display wlan client { roam-in |
roam-out } [ member { ip
IPv4-address | ipv6
IPv6-address } ] [ verbose ] [ |
{ begin | exclude | include }
regular-expression ]
Available in any view