Verifying the configuration, Network requirements, Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 145
133
3.
Configure group-based session-mode load balancing:
# Create load balancing group 1.
[AC] wlan load-balance-group 1
# Add radio 1 of AP 1 and radio 1 of AP 2 to the load balancing group.
[AC-wlan-lb-group-1] ap ap1 radio 1
[AC-wlan-lb-group-1] ap ap2 radio 1
Verifying the configuration
•
Radio 1 of AP 1 and radio 1 of AP 2 are in the same load balancing group, and the radio of AP
3 does not belong to any load balancing group. Load balancing takes effect on only radios in a
load balancing group, so AP 3 does not take part in load balancing.
•
Assume Client 7 wants to associate with AP 2. The number of clients associated with radio 1 on AP
2 reaches 5, and the load gap between AP 2 and AP 1 reaches 4, so Client 7 is associated with
AP 1.
Configuring group-based traffic-mode load balancing
Network requirements
•
As shown in
, all APs operate in 802.11g mode. Client 1 and Client 2 are associated with
AP 1, and no client is associated with AP 2 and AP 3.
•
Configure traffic-mode load balancing on the AC. The traffic threshold is 10% and the maximum
traffic gap is 40%.
•
Traffic-mode load balancing is required on only radio 1 of AP 1 and radio 1 of AP 2.
Figure 70 Network diagram
Configuration procedure
1.
Configure APs on the AC: