Verifying the configuration, Load balancing configuration examples, Configuring session-mode load balancing – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 140: Network requirements, Configuration procedure
128
Verifying the configuration
•
The working channel of radio 1 of AP 1 and that of AP 2 do not change within 20 minutes after
each automatic channel adjustment.
•
The power of radio 1 of AP 1 and that of AP 2 does not change within 30 minutes after each
automatic power adjustment.
Load balancing configuration examples
Configuring session-mode load balancing
Network requirements
•
As shown in
, all APs operate in 802.11g mode. Client 1 is associated with AP 1. Client 2
through Client 6 are associated with AP 2.
•
Configure session-mode load balancing on AC. The threshold, or, the maximum number of sessions
is 5 and the maximum load gap is 4.
Figure 67 Network diagram
Configuration procedure
# Enable session-mode load balancing, and configure the maximum number of sessions and the
maximum load gap as 5 and 4 respectively.
<AC> system-view
[AC] wlan rrm
[AC-wlan-rrm] load-balance session 5 gap 4
[AC-wlan-rrm] quit
# Create a WLAN ESS interface.
[AC] interface wlan-ess 1
[AC-WLAN-ESS1] quit