Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 142
130
Figure 68 Network diagram
Configuration procedure
# Enable traffic-mode load balancing and configure the traffic threshold and the maximum load gap as
10% and 40% respectively.
<AC> system-view
[AC] wlan rrm
[AC-wlan-rrm] load-balance traffic 10 gap 40
[AC-wlan-rrm] quit
# Create interface WLAN-ESS 1.
[AC] interface wlan-ess 1
[AC-WLAN-ESS1] quit
# Create service template 1 of clear type, configure its SSID as traffic-balance, and bind WLAN-ESS1 to
traffic-balance.
[AC] wlan service-template 1 clear
[AC-wlan-st-1] ssid traffic-balance
[AC-wlan-st-1] bind wlan-ess 1
[AC-wlan-st-1] authentication-method open-system
[AC-wlan-st-1] service-template enable
[AC-wlan-st-1] quit
# Create an AP template named ap1 and its model is WA2100, and configure the serial ID of AP 1 as
210235A29G007C000020.
[AC] wlan ap ap1 model WA2100
[AC-wlan-ap-ap1] serial-id 210235A29G007C000020
[AC-wlan-ap-ap1] radio 1 type dot11g
# Bind service template 1 to radio 1 of AP 1.
[AC-wlan-ap-ap1-radio-1] service-template 1
[AC-wlan-ap-ap1-radio-1] radio enable
[AC-wlan-ap-ap1-radio-1] return