Verifying the configuration, Configuring traffic-mode load balancing, Network requirements – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 141
129
# Create service template 1 of clear type, configure its SSID as session-balance, and bind WLAN-ESS1
to session-balance.
[AC] wlan service-template 1 clear
[AC-wlan-st-1] ssid session-balance
[AC-wlan-st-1] bind wlan-ess 1
[AC-wlan-st-1] authentication-method open-system
[AC-wlan-st-1] service-template enable
[AC-wlan-st-1] quit
# Create an AP template named ap1 and its model is WA2100, and configure the serial ID of AP 1 as
210235A29G007C000020.
[AC] wlan ap ap1 model WA2100
[AC-wlan-ap-ap1] serial-id 210235A29G007C000020
[AC-wlan-ap-ap1] radio 1 type dot11g
# Bind service template 1 to radio 1 of AP 1.
[AC-wlan-ap-ap1-radio-1] service-template 1
[AC-wlan-ap-ap1-radio-1] radio enable
[AC-wlan-ap-ap1-radio-1] return
# Create an AP template named ap2 and its model is WA2100, and configure the serial ID of AP 2 as
210235A29G007C000021.
<AC> system-view
[AC] wlan ap ap2 model WA2100
[AC-wlan-ap-ap2] serial-id 210235A29G007C000021
[AC-wlan-ap-ap2] radio 1 type dot11g
# Bind service template 1 to radio 1 of AP 2.
[AC-wlan-ap-ap2-radio-1] channel 1
[AC-wlan-ap-ap2-radio-1] service-template 1
[AC-wlan-ap-ap2-radio-1] radio enable
[AC-wlan-ap-ap2-radio-1] return
Verifying the configuration
Client 1 is associated with AP 1, and Client 2 through Client 6 are associated with AP 2. The number of
clients associated with AP 2 reaches 5, and the load gap between AP 2 and AP 1 reaches 4, so Client
7 is associated with AP 1.
Configuring traffic-mode load balancing
Network requirements
•
As shown in
, all APs operate in 802.11g mode. Client 1 and Client 2 are associated with
AP1, and no client is associated with AP 2.
•
Configure traffic-mode load balancing on the AC. The traffic threshold is 10% and the maximum
load gap is 40%.