H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 169)

157
WMM configuration examples
WMM basic configuration example
Network requirements
As shown in Figure 79 , AC is connected to a Layer 2 switch, and AP and AC are in the same network.
Enable WMM on AC, so that AP and the client can prioritize the traffic.
Figure 79 Network diagram
Configuration procedure
<AC> system-view
# Create interface WLAN-ESS 1.
[AC] interface wlan-ess 1
[AC-WLAN-ESS1] quit
# Create a clear-type WLAN service template, configure its SSID as market, and bind WLAN-ESS 1 to
the service template.
[AC] wlan service-template 1 clear
[AC-wlan-st-1] ssid market
[AC-wlan-st-1] bind wlan-ess 1
[AC-wlan-st-1] authentication-method open-system
[AC-wlan-st-1] service-template enable
# Configure a radio policy. Enable WMM (optional, because WMM is enabled by default).
[AC] wlan radio-policy radiopolicy1
[AC-wlan-rp-radiopolicy1] wmm enable
[AC-wlan-rp-radiopolicy1] quit
# Create a template named ap1, configure the model name as WA2100, and configure the serial ID as
210235A29G007C000020.
[AC] wlan ap ap1 model WA2100
[AC-wlan-ap-ap1] serial-id 210235A29G007C000020
# Bind service template 1 and radio policy radiopolicy1 to interface Radio 1.
[AC-wlan-ap-ap1] radio 1 type dot11a
[AC-wlan-ap-ap1-radio-1] radio-policy radiopolicy1
[AC-wlan-ap-ap1-radio-1] service-template 1
[AC-wlan-ap-ap1-radio-1] radio enable
After WMM is enabled, you can use the display wlan wmm radio command to view WMM-related
information.