H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 172)

160
Traffic differentiation test configuration example
Network requirements
As shown in Figure 82 , AC is connected to L2 switch. AP and AC are in the same network. Configure the
AC to map IP precedence 7 to local precedence 7, allowing such packets to occupy more bandwidth
when being transmitted on the wireless network.
Figure 82 Network diagram
Configuration procedure
# Configure a QoS policy named wmm.
<AC> system-view
# Create a class named wmm, and configure the class to match packets with IP precedence value 7.
[AC] traffic classifier wmm
[AC-classifier-wmm] if-match ip-precedence 7
[AC-classifier-wmm] quit
# Create a traffic behavior named wmm, and configure the traffic behavior to mark packets with local
precedence value 7.
[AC] traffic behavior wmm
[AC-behavior-wmm] remark local-precedence 7
[AC-behavior-wmm] quit
# Create a QoS policy named wmm, and associate class wmm with behavior wmm in the QoS policy.
[AC] qos policy wmm
[AC-qospolicy-wmm] classifier wmm behavior wmm
[AC-qospolicy-wmm] quit
# Apply QoS policy wmm to the incoming traffic of interface GigabitEthernet 1/0/1.
[AC] interface GigabitEthernet 1/0/1
[AC-GigabitEthernet1/0/1] qos apply policy wmm inbound
[AC-GigabitEthernet1/0/1] quit
# Create interface WLAN-ESS 1.
[AC] interface WLAN-ESS 1
[AC-WLAN-ESS1] quit
# Enter the specified priority mapping table view (optional, because the mapping table exists by
default.).
[AC] qos map-table lp-dot11e
# Create a clear-type WLAN service template, configure its SSID as market, and bind WLAN-ESS 1 to
the service template.
[AC] wlan service-template 1 clear
[AC-wlan-st-1] ssid market
[AC-wlan-st-1] bind WLAN-ESS 1
[AC-wlan-st-1] authentication-method open-system