H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 158)

146
Figure 75 Network diagram
Configuration procedure
# Create a WLAN ESS interface.
<AC> system-view
[AC] interface wlan-ess 1
[AC-WLAN-ESS1] quit
# Create service template 1 of clear type, configure its SSID as normal, and bind WLAN-ESS1 to normal.
<AC> system-view
[AC] wlan service-template 1 clear
[AC-wlan-st-1] ssid normal
[AC-wlan-st-1] bind wlan-ess 1
# Configure the authentication method as open-system, and enable service template 1.
[AC-wlan-st-1] authentication-method open-system
[AC-wlan-st-1] service-template enable
[AC-wlan-st-1] quit
# Configure AP1 to operate in normal mode, and provide WLAN service only.
[AC] wlan ap ap1 model WA2100
[AC-wlan-ap-ap1] serial-id 210235A29G007C000020
# Configure the radio type as 802.11g, bind service template 1 to the radio, and enable the radio.
[AC-wlan-ap-ap1] radio 1 type dot11g
[AC-wlan-ap-ap1-radio-1] service-template 1
[AC-wlan-ap-ap1-radio-1] radio enable
# Configure AP2 to operate in monitor mode. It only scans rogue devices, but does not provide access
services.
[AC] wlan ap ap2 model WA2100
[AC-wlan-ap-ap2] serial-id 210235A29G007C000021
[AC-wlan-ap-ap2] work-mode monitor
# Configure the radio type as 802.11g, and enable the radio.