Configuring auto ap – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 28
16
Step Command
Remarks
14.
Enable the remote AP
function.
hybrid-remote-ap enable
Optional.
By default, the remote AP function
is disabled.
•
Before you enable remote AP,
disable online user handshake
function if 802.1X
authentication is used.
•
Do not use the remote AP
function together with the
WLAN mesh function.
15.
Specify a configuration file for
the AP.
map-configuration filename
Optional.
Not specified by default.
16.
Exit AP template view.
quit
N/A
17.
Configure the discovery
policy type as unicast.
wlan lwapp discovery-policy
unicast
Optional.
By default, the AC receives
broadcast discovery messages.
If the unicast policy is specified, the
AC will discard broadcast
discovery messages.
18.
Enable/disable WLAN
radios.
wlan radio { disable | enable } { all
| dot11a | dot11an | dot11b |
dot11g | dot11gn | radio-policy
radio-policy-name }
By default, no WLAN radio is
enabled.
19.
Set the network access server
(NAS)-PORT-ID for an AP.
nas-port-id text
Optional.
By default, no NAS-PORT-ID is
configured for an AP.
20.
Set the NAS-ID for an AP.
nas-id text
Optional.
By default, no NAS-ID is
configured for an AP.
Configuring auto AP
The auto AP feature allows an AP to automatically connect to an AC. When you deploy a wireless
network with many APs, the auto AP function avoids configuration of many AP serial IDs.
To configure auto AP:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enable the auto-AP function.
wlan auto-ap enable
Optional.
Disabled by default.
3.
Enter AP template view.
wlan ap ap-name [ model
model-name [ id ap-id ] ]
The model number is needed only
when you create a new AP
template.
4.
Set auto-AP serial ID.
serial-id auto
N/A