H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 199)

187
3. Enter MP policy view and use command undo role-authenticator enable to set the device not to
play the role of an authenticator.
4. Enable all the radios.
Configuration download failed for zeroconfig device
Symptom
A zero-configuration device forms links but configuration download does not happen.
Analysis
• Channel configuration may be wrong.
• The mapped mesh profile may be wrong.
Solution
1. Go to radio view and use command display this.
2. Verify that the channel must be the same as the MPP. If not, change the channel using command
channel.
3. Verify that the mesh profile mapped to the radio is the same as that mapped to the MPP's radio.
If not, unmap the current mesh profile using command undo mesh-profile. Then map the correct
mesh profile by using command mesh-profile.
Configuration download failed for MP
Symptom
A mesh profile is mapped to the radio of an MP but configuration is not downloaded to the MP.
Analysis
• Verify that the security configuration has been made.
• Verify that the mapped mesh profile is enabled.
• Verify that the radio is enabled.
Solution
1. Configure the security parameters.
2. Enable the mapped mesh profile by using command mesh-profile enable.
3. Enable the radio by using command radio enable.
Debug error: neither local nor remote is connected to MKD
Symptom
Debug error: Neither local nor remote is connected to MKD.
Analysis
Check if MKD service is enabled for the mapped mesh profile.
Solution
Enable the MKD service for the mesh profile by using command mkd-service enable.