Configuring tpc, Configuring auto-tpc, Configuring one-time tpc – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 119
107
Step Command
Remarks
2.
Enter WLAN RRM view.
wlan rrm
N/A
3.
Enable dynamic mesh
channel selection.
mesh calibrate-channel
By default, dynamic mesh channel
selection is disabled.
4.
Configure one-time mesh
DFS.
mesh calibrate-channel pronto
mesh-profile { all |
mesh-profile-number }
By default, one-time mesh DFS is
not configured.
5.
Specify the calibration
interval.
•
dot11a calibration-interval minutes
•
dot11bg calibration-interval minutes
Optional.
By default, the calibration interval
is 8 minutes.
Configuring TPC
NOTE:
•
Make sure the power is not locked (with the power lock command) before enabling TPC. Otherwise TPC
does not work.
•
If you enable TPC, and then configure the power lock command, the last selected power is locked.
•
For more information about the power lock command, see
WLAN Command Reference.
Configuring auto-TPC
With auto TPC enabled, the AC performs TPC for an AP upon certain interference and informs the
adjusted power to the AP after a calibration interval. After that, the AC makes TPC decisions at the
calibration interval automatically.
To configure auto TPC:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter WLAN RRM view.
wlan rrm
N/A
3.
Enable auto TPC for the band.
dot11a calibrate-power
self-decisive
Optional.
Disabled by default.
dot11bg calibrate-power
self-decisive
4.
Specify the calibration
interval.
dot11a calibration-interval
minutes
Optional.
By default, the power calibration
interval is 8 minutes.
dot11bg calibration-interval
minutes
Configuring one-time TPC
With one-time TPC configured, the AC performs TPC for the AP upon certain interference, and informs
the adjusted power to the AP after a calibration interval (defaults to eight minutes, specified with the