H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 173)

161
[AC-wlan-st-1] service-template enable
[AC-wlan-st-1] quit
# Configure a radio policy named radiopolicy1. Then enable WMM for the policy (optional, because
WMM is enabled by default).
[AC] wlan radio-policy radiopolicy1
[AC-wlan-rp-radiopolicy1] wmm enable
[AC-wlan-rp-radiopolicy1] quit
# Create a template named ap1, configure the model name as WA2100, and configure the serial ID as
210235A29G007C000020.
[AC] wlan ap ap1 model WA2100
[AC-wlan-ap-ap1] serial-id 210235A29G007C000020
# Bind service template 1 and radio policy radiopolicy1 to interface Radio 1.
[AC-wlan-ap-ap1] radio 1 type dot11a
[AC-wlan-ap-ap1-radio-1] channel 149
[AC-wlan-ap-ap1-radio-1] radio-policy radiopolicy1
[AC-wlan-ap-ap1-radio-1] service-template 1
[AC-wlan-ap-ap1-radio-1] radio enable
After above configuration, the AC maps IP precedence 7 to local precedence 7.
Troubleshooting
EDCA parameter configuration failure
Symptom
Configuring EDCA parameters for an AP failed.
Analysis
The EDCA parameter configuration of an AP is restricted by the radio chip of the AP.
Solution
1. Use the display wlan wmm radio ap ap-name command to view the support of the radio chip for
the EDCA parameters. Make sure the configured EDCA parameters are supported by the radio
chip.
2. Check that the values configured for the EDCA parameters are valid.
SVP or CAC configuration failure
Symptom
The SVP packet priority mapping function configured with the wmm svp map-ac command does not take
effect.
CAC configured with the wmm edca client command does not take effect.
Analysis
The SVP packet priority mapping function or CAC takes effect only after WMM is enabled.