H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 178)

166
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter radio view.
radio radio-number [ type { dot11a | dot11an |
dot11b | dot11g | dot11gn } ]
N/A
3. Configure radio-based client
rate limiting. client-rate-limit direction { inbound |
outbound } mode { dynamic | static } cir cir Optional.
Disabled by default.
Displaying and maintaining client rate limiting
Task Command Remarks
Display client rate limiting
information.
display wlan client-rate-limit
{ service-template
[ service-template-number ] | ap
[ ap-name radio radio-id ] } [ | { begin
| exclude | include }
regular-expression ]
Available in any view.
Client rate limiting configuration example
Network requirements
AC is connected to Switch, and is in the same network as the AP. Configure client rate limiting on AC, so
that AP limits the incoming traffic in static mode and limits the outgoing traffic in dynamic mode for the
clients.
Figure 84 Network diagram
Configuration procedure
# Enable the WLAN service. (Optional, because the WLAN service is enabled by default)
<AC> system-view
[AC] wlan enable
# Create a WLAN-ESS interface.
[AC] interface wlan-ess 1
[AC-WLAN-ESS1] quit
# Create a WLAN service template of the clear type, configure its SSID as service, and bind interface
WLAN-ESS 1 to the service template.
[AC] wlan service-template 1 clear
AC AP
Client 1
Switch
Client 2