H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 198)

186
# Set the mesh ID as train for mesh profile 1, and enable the mesh profile.
[TrainMP-wlan-mshp-1] mesh-id train
[TrainMP-wlan-mshp-1] mesh-profile enable
[TrainMP-wlan-mshp-1] quit
# Create MP policy train_policy, set the maximum number of links as 8, enable MLSP, and
configure the proxy MAC address as 000f-e287-8700.
[TrainMP] wlan mp-policy train_policy
[TrainMP-wlan-mp-policy-train_policy] link-maximum-number 8
[TrainMP-wlan-mp-policy-train_policy] mlsp enable
[TrainMP-wlan-mp-policy-train_policy] mlsp-proxy mac-address 000f-e287-8700
[TrainMP-wlan-mp-policy-train_policy] quit
# Configure interface WLAN-Radio1/0/2: specify the working channel as 1, and bind MP policy
train_policy and mesh profile 1.
[TrainMP] interface wlan-radio 1/0/2
[TrainMP-WLAN-Radio1/0/2] channel 1
[TrainMP-WLAN-Radio1/0/2] mp-policy train_policy
[TrainMP-WLAN-Radio1/0/2] mesh-profile 1
[TrainMP-WLAN-Radio1/0/2] return
Troubleshooting WLAN mesh link
Authentication process not started
Symptom
A PMK MA request is sent successfully for client 000F-E27C-6C00, but the authentication process is not
started.
Analysis
The portal service is enabled for an MP without wired connection.
Solution
Enter AP template view and use command display this to verify if portal service is enabled. If yes, use
command undo portal-service enable to disable the portal service.
Failed to ping MAP
Symptom
Ping from a station is not working through the MAP.
Analysis
The portal service is disabled and authenticator role is enabled for the MAP.
Solution
1. Enter AP template view and use command display this to verify if portal service is disabled. If yes,
use command portal-service enable to enable the portal service for the MAP.
2. Enter radio view and verify if the MP policy mapped to the radio has role authenticator enabled.
If yes, disable all the radios to which this MP policy is mapped.