H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 34
22
Step Command
Remarks
5.
Configure a channel.
•
Specify a channel number for the
radio:
channel channel-number
•
Set the channel mode to auto. In
this mode, you can lock the current
channel:
{
channel auto
{
channel lock
Optional.
By default:
•
auto mode is enabled.
•
No channel is locked.
For more information about the
commands, see WLAN
Command Reference.
6.
Configure the radio power.
•
Specify the maximum radio
power:
max-power radio-power
•
Lock the current power, and set the
maximum power as the power
after power selection:
power lock
Optional.
By default:
•
The maximum radio power
varies with country codes,
channels, AP models, radio
types and antenna types. If
802.11n is adopted, the
maximum radio power also
depends on the bandwidth
mode.
•
The current power is not
locked.
For more information about the
commands, see WLAN
Command Reference.
7.
Specify the type of
preamble.
preamble { long | short }
Optional.
By default, the short preamble is
supported.
8.
Enable Adaptive Noise
Immunity (ANI) function.
ani enable
Optional.
By default, ANI is enabled.
9.
Apply a radio policy to the
radio.
radio-policy radio-policy-name
Optional.
By default, the default_rp radio
policy is bound to a radio.
The radio policy must have been
configured with the wlan
radio-policy command.
10.
Configure the antenna type. antenna type type
Optional.
The default setting for the
command depends on the device
model.
11.
Configure the maximum
distance that the radio can
cover.
distance distance
Optional.
By default, the radio can cover 1
km (0.62 miles) at most.
12.
Enable the radio.
radio enable
By default, the radio is not
enabled.