H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 219)

207
[AC-WLAN-ESS1] port access vlan 100
[AC-WLAN-ESS1] quit
# Create clear-type service template 1, specify its SSID as Clear-Test, bind the template with
WLAN-ESS1, and enable the template.
[AC] wlan service-template 1 clear
[AC-wlan-st-1] ssid Clear-Test
[AC-wlan-st-1] bind WLAN-ESS 1
[AC-wlan-st-1] service-template enable
[AC-wlan-st-1] quit
3. Configure the APs:
Configure all the APs on the AC. The following takes an AP as an example.
# Create AP template ap1 with the model as WA2620-AGN, and specify the serial ID as
210235A29F007C000151.
[AC] wlan ap ap1 model wa2620-agn
[AC-wlan-ap-ap1] serial-id 210235A29G007C000020
# Apply the service template 1 to radio 1, specify its working channel as 149, and enable radio
1.
[AC-wlan-ap-ap1] radio 1
[AC-wlan-ap-ap1-radio-1] channel 149
[AC-wlan-ap-ap1-radio-1] service-template 1
[AC-wlan-ap-ap1-radio-1] radio enable
# Apply the service template 1 to radio 2, specify its working channel as 1, and enable radio 2.
[AC-wlan-ap-ap1-radio-1] radio 2
[AC-wlan-ap-ap1-radio-2] channel 1
[AC-wlan-ap-ap1-radio-2] service-template 1
[AC-wlan-ap-ap1-radio-2] radio enable
4. Set the multicast rate:
# Log in to the Web interface of the AC, and enter the Rate page as shown in
Figure 101 . Set the
multicast rate to 24 Mbps for 802.11g and 802.11a, and click Apply.