Enabling the green-ap function, Configuring a power supply mode for the ap, Wlan optimization configuration examples – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 216: Optimizing a high-density wlan, Network requirements
204
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enable the AP to receive all
broadcasts.
wlan option rx-broadcast-all
enable
Disabled by default.
Enabling the green-AP function
This feature enables an AP to use one radio when no clients are associated with it to save energy.
To enable the green-AP function:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enable the green-AP function. wlan option green-ap enable
By default, the green-AP function is
disabled.
Configuring a power supply mode for the AP
The AP supports local, PoE, and PoE+ power supply modes. H3C recommends that you use the local or
PoE+ power supply mode to achieve better performance.
To configure a power supply mode for the AP:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Configure a power supply
mode for the AP.
wlan option power-supply { local |
poe | poeplus }
Optional.
By default, the power supply mode
for the AP is local.
This command takes effect only on
the WA3620i-AGN and
WA3628i-AGN APs.
WLAN optimization configuration examples
Optimizing a high-density WLAN
Network requirements
Deploy a WLAN in a six-floor dormitory building. Each floor has 20 dormitory rooms, and each room
has an average of four wireless clients. Deploy four APs at each floor, and connect them to an AC
through a Layer-2 switch in the wiring closet of the floor.
In addition, configure the following features to optimize the WLAN:
•
Reject wireless clients with low RSSI
•
Ignore weak signals