Wlan-dbss interface, Wlan mesh interface, Entering wlan mesh interface view – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 14: Configuring a wlan mesh interface
2
NOTE:
•
Before executing the port access vlan command, make sure the VLAN specified by the
vlanid argument
already exists. You can use the vlan command to create a VLAN. For more information about the port
access vlan command, see
Layer 2 Command Reference.
•
Some configurations made on (only VLAN-related configurations) a WLAN-ESS interface with
WLAN-DBSS interfaces created on it cannot be modified, and the WLAN-ESS interface cannot be
removed either.
WLAN-DBSS interface
WLAN-DBSS interfaces are virtual Layer 2 interfaces. They operate like Layer 2 Ethernet ports of the
access link type. They also support multiple Layer 2 protocols and 802.1X. A WLAN-DBSS interface that
has been created on a WLAN-ESS interface adopts the configuration of the WLAN-ESS interface. On a
wireless switch, the WLAN module dynamically creates a WLAN-DBSS interface for each wireless
access service and removes the interface after the service expires.
WLAN mesh interface
WLAN mesh interfaces are Layer 2 virtual interfaces. You can use them as configuration templates to
make and save settings for WLAN mesh link interfaces. After a WLAN mesh link interface is created, you
are not allowed to change the settings on its associated WLAN mesh interface.
Entering WLAN mesh interface view
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter WLAN mesh interface
view.
interface wlan-mesh
interface-number
If the specified WLAN mesh
interface does not exist, this
command creates the WLAN mesh
interface first.
3.
Restore the default settings of
the WLAN mesh interface.
default
Optional.
Configuring a WLAN mesh interface
Step Command
1.
Configure the description of the WLAN mesh
interface.
description
2.
Configure VLAN settings.
•
port link-type
•
port access
•
port trunk
•
port hybrid