IAI America ASEL - Manual (Page 324)

Part 3 Positioner Mode
Chapter 2 Standard Mode
302
Part 3 Positioner Mode
„ Interpolation (LINE)
With the 2-axis specification, input of the position signal and start signal while this signal is ON will cause
the two axes to perform interpolation operation (the two axes will start simultaneously and arrive at the
target position simultaneously).
To perform interpolation operation, turn ON the interpolation input signal before turning ON the start input
signal.
Ax
is
2
Axis 1
Movement when the interpolation signal is OFF
Movement when the interpolation signal is ON