INFICON MDC-370 Thin Film Deposition Controller - Manual (Page 22)

MDC-370 DEPOSITION CONTROLLER
2.3.8 GRAPH KEY
Pressing the Graph key will bring up one of the four run-time graph screens.
Repeatedly pressing the key will cycle through the different graph screens. Refer
to Section 5 for a detailed description of these status screens.
Figure 2-3 Programming Section
2.3.9 ARROW KEYS
The arrow keys are used to navigate through the programming and setup menu
structure. These keys will auto-repeat if they are held down for more than half a
second.
2.3.10 PROGRAM KEY
Pressing the programming key will bring up the last viewed programming screen.
If a programming screen is already shown, nothing will happen. This key is also
used in conjunction with the Up and Down Arrow keys to adjust the contrast of
the Parameter/Status display. If the screen background is white then press and
hold the Program and the down arrow keys until the text is easy to read. If the
screen background is blue and the text cannot be seen then press and hold the
Program and the up arrow keys.
Figure 2-4 Arrow Keys
FRONT PANEL DISPLAYS AND CONTROLS 2-4