INFICON MDC-370 Thin Film Deposition Controller - Manual (Page 25)

MDC-370 DEPOSITION CONTROLLER
3. BENCH CHECKOUT & INSPECTION
3.1 INSPECTION
Your MDC-370 was released to the carrier in good condition and properly
packed. It is essential to all concerned that the contents of the shipment be
carefully examined when unpacked to assure that no damage occurred in transit.
Check the material received against the packing list to be certain that all elements
are accounted for. Items included with your controller are:
1 MDC-370 Deposition Controller
1 Operation and Service Manual
1 Power cord
1 Source cable (4 pin mini DIN connector)
1 Discrete I/O connector kit (37P D shell)
In addition, you may have ordered one or more of the accessories listed in Section
1.4. If there is evidence of loss or damage:
a) Notify the carrier or the carrier agent to request inspection of the loss
or damage claimed.
b) Keep the shipping containers until it is determined whether or not they
are needed to return the equipment to Maxtek.
3.2 INITIAL POWER UP
Upon initial power up the unit will start with all LED’s lighted. The
Parameter/Status display will show the controller Sign-on screen with its
configuration information. The unit will stay in this state until a key is pressed.
When any key on the front panel is pressed, the operating display and the
Parameter/Status display will return to the last viewed screen prior to loss of
power.
3.3 SAMPLE PROGRAM
The sample program listed below is included in the MDC-370 memory at the time
of shipment. It can be used to check out the controller by running it in Simulate
mode. Follow instructions in Section 4 to navigate through the menu structure.
Check the controller parameter values against the sample program for discrepancy
and change if necessary. Note also, if the source or sensor configuration has been
changed during familiarization with the controller programming, appropriate
source and sensor parameter values also need to be retained for the sample
program to run correctly.
Once the sample program has been checked, use the programming Main Menu,
Edit System Setup, Edit Utility Setup, to select Simulate mode ON, then use Start
to select and run the sample program in Simulate mode.
BENCH CHECKOUT & INSPECTION 3-1