INFICON MDC-370 Thin Film Deposition Controller - Manual (Page 35)

MDC-370 DEPOSITION CONTROLLER
4.1.5.1 VIEW/RUN PROCESS PASSWORD
The View/Run password is required to view or run a process. To set this
password, select View/Edit Process from the Main Menu, select the process from
the Select Process screen. Move the cursor onto the View/Run password, type in
your password (4-digit string), and then press the Enter key. A message will pop
up asking for verification to change the password. Press 1 to confirm and 0 to
cancel the change. Each time you want to view or run this process, you will now
be asked to enter the correct password. Note that the Edit Process password takes
precedence over the View/Run password. If you know the Edit password, you
can also view the process. Once a password other than 0000 has been installed, it
will not be displayed unless re-entered.
4.1.5.2 EDIT PROCESS PASSWORD
The Edit process password is required to edit a process. To set this password,
select View/Edit Process from the Main Menu, select the process from the Select
Process screen. Move the cursor onto the Edit password, type in your password
(4-digit string), then press the Enter key. A message will pop up asking for
verification to change the password. Press 1 to confirm and 0 to cancel the
change. Each time you want to edit this process, you will be asked to enter the
correct password. Once a password other than 0000 has been installed, it will not
be displayed unless re-entered.
4.1.5.3 EDIT MATERIAL PASSWORD
The Edit material password is required to edit a material. To set this password,
select View/Edit Material from the Main Menu, select the material from the
Select Material screen. Move the cursor down to the Material Password
parameter, the last item in the list, type in your password (4 digit string), then
press the Enter key. A message will pop up asking for verification to change the
password. Press 1 to confirm and 0 to cancel the change. Each time you want to
edit this material, you will be asked to enter the correct password. Once a
password other than 0000 has been installed, it will not be displayed unless re-
entered.
4.1.6 ADJUSTING PARAMETER/STATUS DISPLAY CONTRAST
The Parameter/Status display contrast can be adjusted by using the Program key
in conjunction with the Up-arrow and Down-arrow keys. Hold down the Program
key and press the Up-arrow key to increase the contrast. Likewise, hold down the
Program key and press the Down-arrow key to decrease the contrast. It may take
several seconds for the change in contrast to become apparent.
4.2 GETTING STARTED
This section is intended to help new users quickly program the 370 for basic
applications. The section gives the best programming sequence and lists
programming examples. See DETAILED PROGRAMMING in section 4.3 for a
complete programming description.
PROGRAMMING AND CONTROLLER SETUP 4-3