INFICON MDC-370 Thin Film Deposition Controller - Manual (Page 56)

MDC-370 DEPOSITION CONTROLLER
Pressing the right arrow key from this point will bring you to the Calibrate
Sensors screen. In this screen you initiate a sensor tooling factor calibration run
as described in section 10.6.2
38. Material Password (4 digit string)
This parameter defines the edit password for the material. If the password is set
to anything other than 0000 it will not be displayed, and when you attempt to edit
the material you will first be asked to enter the correct password.
4.3.3 SYSTEM SETUP
Choosing the Edit System Setup option from the Main Menu screen will present
the System Setup Menu options as shown in Figure 4-7. These options allow for
setting up the controller to interface with the vacuum system and are described
below.
Figure 4-7 System Setup Menu screen
4.3.3.1 EDIT DISPLAY SETUP
Selecting Edit Display Setup will present the Display Setup screen.
Figure 4-8 Display Setup Screen
1. Pause On Layer Complete (Yes or No)
System Setup: >Edit Display Setup<
Program Inputs
Program Outputs
Program Actions
Edit Sensor Setup
Edit Source Setup
Edit DAC Setup
Edit Utility Setup
Display Setup
Pause On Layer Complete >Yes<
Display Negatives Enabled
Thickness Graph Scale 3-digit
Sensor Status Thickness
Time Display Estimated Layer
Rate Graph Disabled
Power Graph Enabled
↓
PROGRAMMING AND CONTROLLER SETUP 4-24