Rockwell Automation 1756-DMF30 ControlLogix Drive Module - Manual (Page 170)

Publication 1756-UM522B-EN-P - February 2003
B-90 1756-DMD30 Specific Information
740 Position Control
Set bits to enable various postion control functions.
• bit 1 - Enables position regulator output at parameter
318 [Posit Spd Output]
• bit 2 - Enables integrator operation. Resets integrator
if cleared.
• bit 3 - Holds integrator in present state when set.
• bit 4 - When set reverses polarity of offset parameters.
• bit 5 - When set, permits changing the value of
position offsets without changing actual position.
When cleared, position offset is relative to the
re-referenced value or the latched value upon enable if
re-reference was not performed.
• bit 6 - When set disabling the position regulator
causes all accumulated values to be set to the value in
parameter 762 [Mtr Posit Fdbk]. When cleared
disabling the position regulator causes all accumulated
values to be set to the selected position reference
value.
• bit 10 - When set parameter 758 [Pt-Pt Posit Ref] may
be changed without changing actual position.
• bit 13 - Reverses direction of interpolated position and
speed.
• bit 16 - When set position Watch 1 is enabled. When
cleared parameter 741 [Position Status] bit 8 is cleared.
• bit 17 - When set Position Watch 1 output is set when
parameter 763 [Act Motor Posit] is greater than
parameter 780 [PositDtct1 Stpt]. When cleared
Position Watch 1 output is set when parameter 763
[Act Motor Posit] is less than parameter 763 [Act Motor
Posit] [PositDtct1 Stpt].
• bit 18 - When set position Watch 2 is enabled. When
cleared parameter 741 [Position Status] bit 9 is cleared.
• bit 19 - When set Position Watch 2 output is set when
parameter 763 [Act Motor Posit] is greater than
parameter 781 [Posit Dtct2 Stpt]. When cleared
Position Watch 2 output is set when parameter 763
[Act Motor Posit] is less than parameter 781 [Posit
Dtct2 Stpt].
Default: 0000 0000 0000 1010 0000 0000 0000 0000
Options: Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
Bit 8
Bit 9
Bit 10
Bit 11
Bit 12
Bit 13
Bit 14
Bit 15
Bit 16
Bit 17
Bit 18
Bit 19
Bit 20
Bit 21
Bit 22
Bit 23
Bit 24
Bit 25
Bit 26
Bit 27
Bit 28
Bit 29
Bit 30
Bit 31 Reserved
Speed Out En
Integ En
Integ Hold
X Offset Pol
X Offset Ref
ActPosit Rst
Reserved
Reserved
Reserved
Pt-Pt ReRef
Reserved
Reserve
Interp Rev
Reserved
Reserved
X Watch1 En
X Watch1 Dir
X Watch2 En
X Watch2 Dir
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
File:
Group: Position Control
Position Config
No. Name
Description Values