Rockwell Automation 1756-DMF30 ControlLogix Drive Module - Manual (Page 258)

Publication 1756-UM522B-EN-P - February 2003
C-6 1756-DMF30 Specific Information
➊ ➋ ➌
No. Name
Description Values
16 Speed Ref Sel
Enter or write a value to select the source of
the speed reference to the drive.
Default: Val 1 Spd Ref 1
Options: Val 0
Val 1
Val 2 Zero Speed
Spd Ref 1
Spd Ref 2
File:
Group: Speed Control
Reference
80 Speed Reg Ctrl
Enter or write a value to configure the speed
regulator integrator.
Default: 0000 0000
Options: Bit 0
Bit 1
Bit 2
Bit 3
Bit 4 Reserved
Preset Sel
Integ Hold
Integ
Reset
File:
Group: Speed Control
Regulator
11 Spd Ref1 Divide
Speed Ref 1 is divided by this number. Use this
parameter to scale the value of Speed Ref 1.
Default:
Min:
Max:
Type:
File:
Group: 1
-2200000000
2200000000
Non-Linkable Read-Write Floating Point
Speed Control
Reference
No. Description
➊
No. - Parameter Number.
= Stop drive before changing this parameter.
➋
Name - Parameter name as is appears in DriveExecutive software.
Description - Brief description of parameter function.
➌
Values - Defines the various operating characteristics of the parameter. Three types exist
ENUM Default:
Options:
File:
Group: Lists the value assigned at the factory.
Displays the selections available.
Lists the major parameter file category.
Lists the parameter group within the file.
Bit Default:
Options:
File:
Group: Lists the bit pattern assigned at the factory.
Displays the selections available.
Lists the major parameter file category.
Lists the parameter group within the file.
Numeric Default:
Min:
Max:
Type:
File:
Group
Lists the value assigned at the factory.
Displays lowest possible setting.
Displays highest possible setting.
Indicates if parameter is linkable, read-write, read-only, and data type (i.e. integer, floating
point, boolean).
Lists the major parameter file category.
Lists the parameter group within the file.