Rockwell Automation 1756-DMF30 ControlLogix Drive Module - Manual (Page 60)

Publication 1756-UM522B-EN-P - February 2003
5-16 Configuring the Drive Module
Using DriveExecutive to
Configure Drive Module Configure the Drive Module’s Peer Communication
On the SynchLink Setup Tab
Select the Receive
and Transmit Formats
Configure the
Multiplier Block
Select source
parameters for
Buffered Data
transmissions
Select source
parameters for
Direct Data, if
the sources are
drive
parameters
Click SynchLink Node Configuration to open
SynchLink Node Configuration Window
The settings you make on this tab determine what the
module does during every SynchLink Update cycle
Select sources
for Direct Data
transmissions
Select Peer
Communication from
Drive Menu