4 checking the configuration, 3 configuring unidirectional pap, 1 establishing the configuration task – Nortel Networks 8000 User Manual
Page 135: Applicable environment, 5 checking the configuration -25, 1 establishing the configuration task -8, 3 configuring unidirectional pap -9, 2 encapsulating an interface, With p
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
6 PPP and MP configuration
6.2.4 Checking the configuration
Run the following commands to check the previous configuration.
Action
Command
Check the PPP configuration
and status of the interface.
display interface [
interface-type
[
interface-number
] ]
[
| { begin | exclude | include }
regular-expression
]
Run the
display interface command. When PPP configuration of an interface appears the
configuration succeeds. For example:
<Nortel> display interface Serial 6/0/0
Serial6/0/0 current state : UP
Line protocol current state : UP
Description : Huawei, Quidway Series, Serial6/0/0 Interface
The Maximum Transmit Unit is 1500 bytes, Hold timer is 10(sec)
Internet Address is 12.1.1.1/24
Link layer protocol is PPP
LCP initial
QoS max-bandwidth : 64 Kbps
Output queue : (Urgent queue : Size/Length/Discards) 0/50/0
Output queue : (Protocol queue : Size/Length/Discards) 0/1000/0
Output queue : (FIFO queue : Size/Length/Discards) 0/256/0
Physical layer is synchronous, Loopback not set, NRZ Code
Baudrate is 64000 bps, Interface is no cable
Statistics last cleared: never
Last 300 seconds input rate 0 bits/sec, 0.00 packets/sec
Last 300 seconds output rate 0 bits/sec, 0.00 packets/sec
Input: 0 packets, 0 bytes
0 input errors, 0 runts, 0 giants, 0 parity errors
0 CRC, 0 overruns, 0 frame errors
Output:0 packets, 0 bytes
0 output errors, 0 underruns, 0 parity errors, 0 describe errors
0 owner errors, 0 Other errors
DCD=DOWN DTR=DOWN DSR=DOWN RTS=DOWN CTS=DOWN
6.3 Configuring unidirectional PAP
6.3.1 Establishing the configuration task
Applicable environment
The PAP authentication method uses the plain-text password. The username and password can
be added to the local user list through Authentication, Authorization and Accounting (AAA)
or the Remote Authentication Dial in User Service (RADIUS) server.
PAP authentication divides into the following two types:
•
Unidirectional: one part works as the authenticator, and the other as the authenticated.
•
Bidirectional: two parts can work as both the authenticator and the authenticated.
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
6-9