1 establishing the configuration task, Applicable environment, 1 establishing the configuration task -7 – Nortel Networks 8000 User Manual
Page 155
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
6 PPP and MP configuration
Run the
display interface virtual-template
command to view status of a VT. For example:
<RouterB> display interface virtual-template
Virtual-TemplateO current state : UP
Line protocol current state :UP (spoofing)
Description : NORTEL, Nortel Series, Virtual-TemplateO Interface, Route Port
The Maximum Transmit Unit is 1500 bytes
Internet Address is 10.1.1.2/24
Link layer protocol is PPP
LCP initial, MP opened
Physical is None, baudrate is 64000 bps
QoS max-bandwidth : 64 Kbps
Output queue : (Urgent queue : Size/Length/Discards) 0/50/0
Output queue : (Protocol queue : Size/Length/Discards) 0/1000/0
Output queue : (FIFO queue : Size/Length/Discards) 0/256/0
Last 300 seconds input rate 0 bits/sec, 0 packets/sec
Last 300 seconds output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
Run the
display ppp mp
command to check binding information about an MP. For example:
<Nortel> display ppp mp
Bundle Multilink, 1 member, slot 6, Master link is Virtual-Template0:1
0 lost fragments, 0 reordered, 0 unassigned, 0 interleaved,
sequence 0/0 rcvd/sent
The bundled son channels are:
Serial6/0/0
6.7 Configuring MP authentication binding through the
VT
6.7.1 Establishing the configuration task
Applicable environment
To obtain broader bandwidth, you can bind multiple PPP links together into a VT.
The binding authentication includes:
•
User name authentication
•
Endpoint discriminator authentication
•
Username and endpoint discriminator authentication.
Currently, MP does not support binding the interfaces of different boards on a router. You can
only bind MP based on the user name.
When you authenticate the MP binding, the process contains two steps as follows:
•
The bound PPP interface must pass the PAP and CHAP authentication.
•
The authenticated object must find the corresponding VT according to the username. If
no VT corresponds to it, the binding cannot succeed.
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
6-29