5 maintaining atm, 6 configuration example of ipoa, Networking requirements – Nortel Networks 8000 User Manual

Page 457: 11 configuration examples -31, 5 maintaining atm -14, 4 configuring the service, Type of pvc, Caution

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

11 High-speed ATM configuration

Nortel Secure Router 8000 Series

Configuration -WAN Access

11.5 Maintaining ATM

A

CAUTION

Debugging affects the system performance. After the debugging, run the

undo debugging all

command to disable it immediately.

When ATM runs abnormally, run the

debugging

command in user view to debug the ATM

interface and locate the fault.

For the procedure of outputting the debugging information, refer to the chapter "Maintenance
and Debugging" in the Nortel Secure Router 8000 Series Configuration Guide - System

Management. For detailed debugging commands, refer to the Nortel Secure Router 8000

Series Command Reference.

Action

Command

Enable ATM error debugging.

debugging atm error

[

interface atm

interface-number [ .subinterface ] [

pvc

{ pvc-name

[ vpi/vci ] | vpi/vci } ] ]

Enable ATM event debugging.

debugging atm event

[

interface atm

interface-number [ .subinterface ] [

pvc

{ pvc-name

[ vpi/vci ] | vpi/vci } ] ]

Enable ATM packet debugging.

debugging atm packet

[

bridge

|

inarp

|

ip

]

[

interface atm

interface-number [ .subinterface ] [

pvc

{ pvc-name [ vpi/vci ] | vpi/vci } ] ]

Enable all ATM debugging.

debugging atm all

11.6 Configuration example of IPoA

Networking requirements

In Figure 11-2,connect routers A, B and C to the ATM network. All the PVCs on ATM
interfaces of the three routers use the IPoA application mode.

11-14

Nortel Networks Inc.

Issue 5.3 (30 March 2009)

Advertising