4 configuring x.25 switching route, 5 checking the configuration, 4 checking the configuration -37 – Nortel Networks 8000 User Manual
Page 236: 4 configuring x.25 switching -29, Configuring x.25 switching route, Checking the configuration
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
7 LAPB and X.25 configuration
The command adds the interface into a hunt group.
Step 4
Run:
channel xot ip-address
The command adds the XOT channel into a hunt group.
A hunt group can hold a maximum of 10 synchronous serial ports or XOT channels.
You cannot add the XOT channel into the hunt group that adopts vc-number channel.
—End
7.5.4 Configuring X.25 switching route
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
x25 switch svc x.121-address [ sub-dest destination-address ]
[ sub-source
source-a^^ress ] hunt-group hunt-group-name
The command adds an X.25 switching route whose forwarding address is a hunt group.
Step 3
Run:
x25 switch svc x.121-address [ sub-dest destination-address ]
[ sub-source
source-a^^ress ] interface serial number
The command configures an X.25 switching route whose forwarding address is an interface.
—End
7.5.5 Checking the configuration
Run the following commands to check the previous configuration.
Action
Command
Display the X.25 switch
routing table.
display x25 switch-table svc
{
dynamic
|
static
}
Display X.25 switch
PVC table.
display x25 switch-table pvc
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
7-33