Nortel Networks 8000 - Manual (Page 403)

Nortel Secure Router 8000 Series
Configuration -WAN Access 10 Low-speed ATM configuration
Step 3 Run:
atm-class atm-class-name
The command applies the ATM-class.
—End
Applying the ATM-class to a PVC
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
interface atm interface-number[.subinterface ]
The ATM interface or the sub-interface view appears.
Step 3 Run:
pvc { pvc-name vpi/vci | vpi/vci }
The command creates a PVC and the PVC view appears.
Step 4 Run:
atm-class atm-class-name
The command applies the ATM-class.
The same parameters that you configure directly in PVC view have the highest precedence.
Those of the ATM-class applied on the PVC and applied on the ATM interface rank second
and third respectively.
—End
10.3.4 Checking the configuration
Run the following commands to check the previous configuration.
Action Command
Check the configuration and
status of the ATM interface or
sub-interface.
display interface atm [ interface-number
{.subinterface ] ] [ | { begin | exclude | include }
regular-expression ] [ interface-type ]
Check information about the
PVC.
display atm pvc-info [ interface interface-type
interface-number [ .subinterface ] [ pvc { pvc-name
[ vpi/vci ] | vpi/vci } ] ]
Check information about the
ATM-class.
display atm class [ atm-class-name ]
Issue 5.3 (30 March 2009) Nortel Networks Inc. 10-17