Networking requirements, Configuration roadmap, Data preparation – Nortel Networks 8000 User Manual
Page 185: Configuration procedure
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
6 PPP and MP configuration
return
6.12.5 Example for configuring MP direct binding using the VT
Networking requirements
You connect Router A and Router B through two pairs of serial ports. Configure MP binding
using virtual-template without any authentication.
Figure 6-4 Networking diagram of the MP binding
VT1
8.1.1.1/24
Serial1/0/0________
VT1
8.1.1.2/24
Serial1/0/0^ig!<
Serial1/0/1
RouterA
Serial1/0/1
RouterB
Configuration roadmap
The configuration roadmap is as follows:
1.
Configure virtual interface templates on Router A and Router B.
2.
Configure the interfaces to work in MP mode.
3.
Restart the interfaces to validate the configuration.
Data preparation
To complete the configuration, you need the following data:
•
The numbers of the VT on RouterA and RouterB are bothl
•
The IP addresses of the VTs on Router A is 8.1.1.1/24
•
The IP addresses of the VTs on Router B is 8.1.1.2/24
Configuration procedure
Step 1 Configure Router A.
• Create and configure the VT.
<RouterA> system-view
[RouterA] interface Virtual-Template 1
[RouterA-Virtual-Templatel] ip address 8.1.1.1 255.255.255.0
[RouterA-Virtual-Templatel] quit
• Configure Serial 1/0/0.
[RouterA] interface serial 1/0/0
[RouterA-Seriall/0/0]
[RouterA-Seriall/0/0]
[RouterA-Seriall/0/0]
[RouterA-Seriall/0/0]
[RouterA-Seriall/0/0]
link-protocol ppp
ppp mp virtual-template 1
shutdown
undo shutdown
quit
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
6-59