Nortel Networks 8000 User Manual

Page 301

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Nortel Secure Router 8000 Series

Configuration -WAN Access

8 Frame relay configuration

interface interface-type interface-number

The FR interface view appears.

Step 3 Run:

link-protocol fr [ ietf | nonstandard ]

The command configures the link layer protocol of the interface as FR.

By default, the link layer protocol encapsulation of the interface is PPP. When the FR

protocol is encapsulated, by default, the encapsulation format of the frame is IETF.

m

NOTE

• Modifing the FR encapsulation format of the interface can delete the original FR configuration on

the interface. After you modify the FR encapsulation format, you need to re-configure the FR.

• After the link layer of the interface is changed, first run the shutdown command to disable the

interface. Then run the undo shutdown command to restart the interface to ensure that the
configuration is valid.

Step 4 Run:

fr interface-type dte

The command configures the FR interface type as DTE.

By default, the FR interface type is DTE. Therefore, this Step is optional.

Step 5 Run:

ip address ip-address { mask | mask-length }

The command configures the IP address of the interface.

Step 6 Run:

fr dlci dl ci

The command configures the DLCI of the FR link.

If the type of a main interface is DTE, and the interface is enabled with dynamic address

mapping, you can automatically identify the local DLCI according to the peer device. In this

case, this step is optional.

If the DLCI at the DCE side changes and if no service is a^ected, then restart interfaces on

both ends. You can also run the

reset fr inarp command to clear the mapping to ensure the

DTE can learn correct address mapping.

If the DLCI at DTE side is configured, it must be the same as that configured at DCE side.

Step 7 Run:

fr inarp [ ip [ dlci-number ]

]

The dynamic address mapping is enabled.

CQ NOTE

• For Nortel products, FR interfaces are enabled with dynamic address mapping by default.

• The dynamic address mapping can be configured only on an FR main interface.

—End

Issue 5.3 (30 March 2009)

Nortel Networks Inc.

8-11

Advertising