Troubleshooting procedure, Fault description – Nortel Networks 8000 User Manual
Page 365
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
8 Frame relay configuration
Troubleshooting procedure
Do as follows on the routers:
Step 1
Check whether there are routes to the peer by using the
display ip routing-table
command. If
there are no routes to the peer, run the
display this interface
command in the interface view,
and check whether the physical status and the link protocol of the interface are Up.
Step 2
Check the interface status by using the
display this interface
command. If the status of the
interface is Down, reconnect the physical link.
Step 3
Check the link layer protocol by using the
display this interface
command. If the status of
the protocol is Down, run the
link-protocol
command to configure interfaces at both sides
with the same link protocol.
Step 4
Check the status of the tunnel by using the
display interface tunnel
command. If the tunnel
is Down, run the
undo shutdown
command to restart the tunnel. If the link protocol of the
tunnel is Down, the tunnel is not affected.
Step 5
Check whether the DLCIs of tunnel interfaces on two ends are consistent by using the
display
fr switch-table all
command. If the interfaces are not consistent, run the
undo fr switch
command to delete the existing switching PVC, and then run the
fr switch
command and
configure DLCIs of tunnel interfaces on both ends to be consistent.
--- End
8.15.4 Only one end can ping through the other end after
configuring the frame relay PVC
Fault description
As shown in Figure 8-13, you configure Router A and Router B with the FR PVC.
Figure 8-13
Diagram of configuring the FR PVC
RouterA
DLCI=17
DLCI=18
3.1.1.1/24 RouterB
Serial1/0/0.2
^g»
Serial1/0/0
2.2.2.67/24
Serial1/0/0.1
2.2.2.65/24
DLCI=17
The allocation of the IP address and DLCI is as follows:
•
On Router A, the IP address and DLCI of the father-interface Serial1/0/0 are 2.2.2.67/24
and 17.
•
On Router B, the IP address and DLCI of the sub-interface Serial1/0/0.1 are 2.2.2.65/24
and 17.
•
On Router B, the IP address and DLCI of the sub-interface Serial1/0/0.2 are 3.1.1.1/24
and 18.
The configuration file on Router A is as follows:
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
8-75