Preconfiguration tasks, Data preparation, Configuration procedures – Nortel Networks 8000 User Manual
Page 156: 2 creating a vt, 2 creating a vt -30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6 PPP and MP configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
Preconfiguration tasks
Before configuring MP authentication binding using the VT, complete the following tasks:
•
Configuring physical attributes of the router interface
•
Configuring the link layer protocol of the interface as PPP
•
Configuring the authentication mode (CHAP or PAP) of the PPP interfaces
Data preparation
To configure MP authentication binding using the VT, you need the following data.
No.
Data
1
Interface number of the router
2
Number of the VT
3
IP addresses and subnet masks of the VT
Configuration procedures
No.
Procedure
1
2
Configuring a PPP interface to work in MP mode
3
Où NOTE
You need to configure the local end and the peer end separately. The methods are the same.
6.7.2 Creating a VT
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
interface virtual-template number
The VT is created.
Step 3
Run:
ip address ip-address { mask | mask-length }
[ sub ]
The command assigns the IP address to the VT.
Step 4
Run:
6-30
Nortel Networks Inc.
Issue 5.3 (30 March 2009)