Nortel Networks 8000 - Manual (Page 62)

Nortel Secure Router 8000 Series
Configuration -WAN Access 4 POS and CPOS interface configuration
4
POS and CPOS interface configuration
About this chapter
The following table shows the contents of this chapter.
Section Description
4.1 Introduction This section describes basic concepts of POS interfaces
and CPOS interfaces.
4.2 Configuring POS
interfaces This section describes how to configure a POS interface.
See:Example for directly connecting routers through POS
interfaces
4.3 Configuring STM-1 CPOS
interfaces This section describes how to configure a CPOS
interface.
4.4 Configuring E1/T1
channels of the CPOS
interface This section describes how to configure an E1/T1 channel
of CPOS interfaces.
See Example for configuring STM-1 CPOS interfaces.
4.5 Configuring synchronous
serial interfaces
This section describes how to configure synchronous
serial interfaces formed by the CPOS interface.
4.6 Maintaining POS and
CPOS interface
This section describes how to maintain the POS and
CPOS interface.
4.7 Configuration examples This section provides several configuration examples for
POS and CPOS interfaces.
4.8 Troubleshooting This section describes how to diagnose and remove the
fault on POS and CPOS interfaces.
Issue 5.3 (30 March 2009) Nortel Networks Inc. 4-1