4 maintaining pppoe, 5 configuration examples, Networking requirements – Nortel Networks 8000 User Manual

Page 473: Configuration roadmap, 6 configuration example of ipoa -14, 4 maintaining pppoe -8, 3 configuring pppoe, Parameters

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

12 PPPoE configuration

Nortel Secure Router 8000 Series

Configuration -WAN Access

12.4 Maintaining PPPoE

After confirming the statistics about the PPPoE session to be cleared, run the following

reset

command.

Action

Command

Clear the setup speed statistics of PPPoE

sessions.

reset pppoe-server session statistic interface

interface-type interface-number

12.5 Configuration examples

Networking requirements

The host uses PPPoE to access the Internet through the Router.

You connect the Router to the host through Ethernet interface 1/0/0, and to the Internet

through POS 2/0/0.

A

If you adopt the simple option, the password is stored in the configuration files in plain text.
You obtain the login user with low class the password by checking the configuration mode.

Therefore, you are recommended to use the cipher option.

Figure 12-1

PPPoE networking diagram

Host

GEI/0/^^^:^ POS2/0/0

Host

Router

POS2/0/0 / , ,

, ^

Configuration roadmap

The configuration roadmap is as follows:

1.

Configure the authentication mode as CHAP.

2.

Allocate the IP address pool.

3.

Configure the PPPoE protocol.

12-8

Nortel Networks Inc.

Issue 5.3 (30 March 2009)

Advertising