TOHO ELECTRONICS TTM200 - Manual (Page 134)

48-7009-E 5-64
■ Regarding the time signal output function
A signal of time signal can be output for each step during a program run. Timers 1 to 3 for step time
are usable as is, as a timer independent from those is used for the signal.
Note The function is active only during a run. Timer operation is also halted during In-stop or
After-end.
Note The timer is reset at step switchover and END transition.
Note Timer operation is skipped to make transition with a step time if a time longer than the step time is set.
Example for StEPN

3
Step 1 Step 2 Step 3
Step start
PV
On delay
Off delay
Timer 1
Soak start
On delay
Off delay
Timer 2
Step start
On delay
Off delay
Timer 3
The count of repetition: 1 The count of repetition: 1 The count of repetition: 1
The count of repetition: 1 The count of repetition: 1 The count of repetition: 1
The count of repetition: 2 The count of repetition: 0 (unlimited) The count of repetition: 3
All three timers (Timers 1 to 3) are usable at each step. The diagram indicates an example of Timer 1
set for step start, Timer 2 for soak start and Timer 3 for step start. To use a timer for each step,
parameters necessary for the timer function are first set in the bank [SET 20 bNK01 to 16]. For
details, see Section 5.4.5 Timer function (P5-31 to 37).
To use On or Off outputs from Timers 1 to 3 as time signals, set the output destination [o*F] in
“connection destination setting table” to either [5 to 16].
(Connection destination setting table)
SEt05
oUt1
to
SEt11
oUt7
Setting content Initial value
1
o1F
to
o7F
0 Primary output
o1F:0
o2F:2
to
o7F:2
1 Secondary output
2 Event output
3 RUN output
4 RDY output
5 Timer 1 output
6 Timer 1 during-on-delay output
7 Timer 1 during-off-delay output
8 Timer 1 during-[on + off]-delay output
9 Timer 2 output
10 Timer 2 during-on-delay output
11 Timer 2 during-off-delay output
12 Timer 2 during-[on + off]-delay output
13 Timer 3 output
14 Timer 3 during-on-delay output
15 Timer 3 during-off-delay output
16 Timer 3 during-[on + off]-delay output
17 Transmission output (for analog output)
18 Program run end output