TOHO ELECTRONICS TTM200 - Manual (Page 67)

48-7009-E 4-26
4.2.8 How to set priority screens
How to set priority screens is described.
Constant value run mode screen
PV value (present value)
SV value (target value)
Hold MODE key pressed for 2 seconds.
Input 1 setting screen
Each set screen
Each setting mode
Press ▼ key twice.
Priority screen setting screen
Each set screen
Each setting mode
Press MODE key once.
S19-1 Priority screen 1 setting screen
* A parameter switched over to the priority screen is set in this screen.
* Use the ▲/▼ key for the setting.
* The value is set at “OFF” at factory shipment.
* Each parameter is displayed in sequence. When a desired parameter
is displayed in the priority screen, press the MODE key to move to the
next screen.
Press MODE key 15 times.
S19-16 Priority screen 16 setting screen
* A parameter switched over to the priority screen is set in this screen.
* Use the ▲/▼ key for the setting.
* The value is set at “OFF” at factory shipment.
* A parameter that is already set for the priority screen is not displayed.
* Parameters are displayed in the operating mode screen in the sequence that they are set.
* Holding the MODE key pressed for 2 seconds moves each setting screen to the operating mode
screen.
* In about 2 minutes, each setting screen (or any setting screen) automatically moves back to the
operating mode screen.
H
o
ld
MOD
E
k
ey
p
re
ss
ed
fo
r
2
se
co
n
d
s.
For program run mode screen:
PV value (present value)
SV value (PRoG)
Hold MODE key pressed for 2 seconds
Setting mode is the same as that for constant
value run mode.
(To input 1 setting screen)