TOHO ELECTRONICS TTM200 - Manual (Page 69)

48-7009-E 4-28
Continued from the previous page
Hold MODE key pressed for 3 seconds.
Holding the MODE key pressed for 3 seconds in any
screen above results in changing the screen.
Use the ▲/▼ key to change
the item to be displayed.
(Some items are not
displayed depending on the
equipment specification.)
Use the MODE key to change
the item to be displayed.
(Some items are not
displayed depending on the
equipment specification.)
Use the MODE key to change
the item to be displayed.
(Some items are not displayed
depending on the equipment
specification.)
MODE key
MODE key
MODE key
MODE key
MODE key
* Each SET item is also set for blind setting after moving the screen to the
parameter screen, using the MODE key.
* Always use the FUNC key to set screens for the blind settings.
When the character “OFF” in the lower row (red) is displayed, the
screen is in a blind state.
* Holding the MODE key pressed for 3 seconds in each screen results in
returning to .
* How to terminate the blind setting mode
1) After turning the power off, turn it back on. After the initial screen is displayed, the operating mode screen is
displayed again.
2) Holding the MODE key pressed for 3 seconds in each SET screen moves the screen to the PV/SV blind setting
screen.
Then, holding the MODE key pressed for about 10 seconds results in displaying the operating mode screen again.
* In the diagram above, only SET1 and SET20 are shown; other SET** are skipped.
The blind status of each parameter can also be settable for other SET**.