TOHO ELECTRONICS TTM200 - Manual (Page 89)

48-7009-E 5-19
5. Event sensitivity setting screen
* Event sensitivity is set in this screen.
* Use the ▲/▼ key for the setting.
* The value is set at “0” at factory shipment.
Setting “0” to “1” results in setting the sensitivity range of the lower limit alarm to 1 °C.
Temperature that an alarm enters: 170 °C
Temperature that an alarm cancels: 169 °C
Continued from the previous page
* Holding the MODE key pressed for 2 seconds moves each setting screen to the run mode screen.
* In about 2 minutes, each setting screen (or any setting screen) automatically moves back to the run mode screen.