Rice Lake PR5230 Fieldbus Transmitter - Manual (Page 104)

Commissioning PR 5230 Instrument Manual
EN-104 Sartorius
5.3.8 Setup Menu (VNC)
- Serial ports parameter
- Printer <none>, Builtin RS232, Builtin RS485
- Param Assigned to, Protocol, Baudrate, Bits, Parity, Stopbits, output mode
- Config See ‘Printing parameter’.
- Remote display <none>, Builtin RS232, Builtin RS485
- Param Assigned to, Protocol, Baudrate, Bits, Parity, Stopbits, Mode
- JBUS/MOD-Bus <none>, Builtin RS232, Builtin RS485
- Param Assigned to, Protocol, Baudrate, Bits, Parity, Stopbits, Slave, Modbus mode
- SMA <none>, Builtin RS232, Builtin RS485
- Param Assigned to, Protocol, Baudr., Bits, Parity, Stopbits
- xBPI-Port <none>, Builtin RS232, Builtin RS485
- Param Assigned to, Baudrate, Bits, Parity, Stopbits
- Asycom <none>, Builtin RS232, Builtin RS485
- Param Assigned to, Protocol, Baudr., Bits, Parity, Stopbits, Slave
- Date & Time Change date and time
- Operating parameter
- Address Address of the instrument
- PIN Access code for setup.
-Sequencenumber Counter for print jobs
- Set Tare Key Tare& reset tare, tare&tare again, disabled
- Set Zero Key Only when not tared, reset tare on zeroset, disabled
- Printing parameter
- Printing mode Print selected items, via Nice Label
- Printing interval Print interval
- Printing interval unit Select: Seconds, Minutes, Hours, Meas. time
- Print layout Item 1…6 Select: -none-, Grossweight, Net weight, Tare weight, Date & Time, Sequencenumber,
CR/LF, Device address, displayed weight, Form feed
- Fieldbus parameter Fieldbus protocol (read only), only if PR 1721/4x is installed in Slot 2,
see Chapter 5.6.5.
- Network parameter HW Address (read only), Hostname, Use DHCP, IP address, Subnet mask, Default
gateway, Remote access VNC-Client